Scope: the 32-position SDC3 connector shown in MoTeC’s SDC3 user manual, Appendix B, printed pages 15–16, also shown in the SDC3 support article. This is not the SDC2 two-connector pinout. Confirm the exact unit and connector face with MoTeC.
Manufacturer documentation conflict: MoTeC’s SDC3 product page describes two 24-pin connectors, whereas its linked SDC3 manual and technical support diagram show one numbered 32-position connector. The table below is limited to that illustrated 32-position configuration; do not assume it applies to another connector layout.
| Position | Function and source notes |
|---|---|
| 1 | Not connected |
| 2 | CAN high |
| 3 | Not connected |
| 4 | C.DIFF minus/down switch input, switch to 0 V |
| 5 | Rear diff temperature input, 0 V when hot |
| 6 | Auto/manual switch input, future use, switch to 0 V |
| 7 | Diff relay control output, active low |
| 8 | Brake pedal input, optional, 12 V when applied |
| 9 | Front right speed input, optional magnetic or Hall |
| 10 | Front left speed input, optional magnetic or Hall |
| 11 | Battery positive input, electronics power |
| 12 | Not connected |
| 13 | Diff power input, solenoid power from relay |
| 14 | Diff power input, solenoid power from relay |
| 15 | Diff drive positive output, solenoid positive |
| 16 | Handbrake input, optional, 0 V when on |
| 17 | Battery negative input |
| 18 | CAN low |
| 19 | Yaw sensor input, optional |
| 20 | Lateral G input, optional |
| 21 | Yaw reference, optional 2.5 V reference for yaw and lateral G |
| 22 | C.DIFF plus/up switch input, switch to 0 V |
| 23 | AV2, reserved for future use |
| 24 | AV1, reserved for future use |
| 25 | Throttle position input, optional 0–5 V |
| 26 | Rear right speed input, optional magnetic or Hall |
| 27 | Rear left speed input, optional magnetic or Hall |
| 28 | Battery negative input |
| 29 | Battery negative input |
| 30 | Battery negative input |
| 31 | Battery negative input |
| 32 | Diff drive negative output, switched solenoid negative |
Optional inputs and reserved positions are designated as such in the source. The default documented method obtains wheel speed and ABS status over CAN; optional direct inputs require the appropriate configuration. Source: MoTeC SDC3 manual, Appendix B and speed measurement.