Tuning Wiki
Browse MoTeC Subaru

Scope: MoTeC SDC2, part 14010, using the two 24-position connectors labelled A (grey) and B (white) in MoTeC’s SDC2 manual dated 22 February 2008, Appendix B, printed pages 14–15. This reference is not the 40-pin SDC or the 32-position SDC3. Verify the actual module, connector face, region, model year and wiring with MoTeC.

Connector A, grey

PositionFunction and source notes
A1Lateral G input
A2Throttle position sensor input
A3Thumbwheel input, 0 V open to 5 V locked
A4Brake pedal input, 12 V when applied
A5Handbrake input, 0 V when on
A6Tacho input, 2 pulses per rpm
A7AV1, reserved for future use
A8AV2, reserved for future use
A9ECU communications, RS232 to MoTeC M800 OEM WRX78
A10Yaw sensor input
A110 V to yaw and G sensor
A12Not connected
A13Auto/manual switch input, for future use
A14Rear diff temperature input, 0 V when hot
A19Yaw/G sensor reference input, 2.5 V
A20Battery negative input, electronics ground
A21Yaw test output
A22Yaw/G sensor supply, 12 V
A23Thumbwheel supply, 5 V

A15–A17 are not listed in the cited printed manual. MoTeC’s online support table lists them as not connected; they are omitted here rather than treated as verified on all revisions.

Disputed CAN positions

Do not use this page to assign CAN polarity on A18 and A24. The printed MoTeC manual calls A18 ABS/steering CAN high and A24 CAN low; MoTeC’s online support table gives A18 CAN low and A24 CAN high. Confirm the actual unit and loom with MoTeC before connecting these positions.

Connector B, white

PositionFunction and source notes
B1Diff mode 3 dash lamp output, active low
B2Diff mode 2 dash lamp output, active low
B3Diff mode 1 dash lamp output, active low
B4Diff open dash lamp output, active low
B5Battery positive input, electronics power
B6Battery positive input, electronics power
B7Diff power input, solenoid power from relay
B8Diff power input, solenoid power from relay
B9Diff drive positive output, solenoid positive
B10Diff relay control output
B11Auto/manual dash lamp output, active low
B12Diff locked dash lamp output, active low
B13Diff mode 4 dash lamp output, active low
B140 V to thumbwheel
B15Not connected
B16Battery negative input, electronics ground
B17Not connected
B18Rear left speed sensor input, optional magnetic or Hall
B19Rear right speed sensor input, optional magnetic or Hall
B20Front left speed sensor input, optional magnetic or Hall
B21Front right speed sensor input, optional magnetic or Hall
B22Diff ground input, solenoid ground
B23Diff ground input, solenoid ground
B24Diff drive negative output, switched solenoid negative

Wheel-speed inputs B18–B21 are optional; in the documented standard installation the controller receives speeds and ABS status over the ABS CAN bus. Confirm sensor configuration and the model-specific harness. Source: MoTeC SDC2 manual, Appendix B.