Tuning Wiki
Browse Renault
Applies to

Check the hardware and software limits stated in this article.

Scope and evidence

This page outlines the sequence in which the Megane II RS 225, 230 and R26 (F4Rt turbo, Sagem S3000) are commonly upgraded. It is built from vendor product listings and a tuning guide that were seen only through search summaries (the guide itself returned an access error and the vendor pages were rate-limited), so the details are indicative and should be checked with the supplier. Baseline remap expectations are on F4R and F4RT Sagem remap expectations, and clutch and heat limits on the 225 limits page.

Step 1: calibration

The factory ECU can be tuned to cover most performance changes, from filter and exhaust through to hybrid turbos, flowed heads and larger injectors, according to the guide. A custom dyno map was quoted at roughly £395.

Step 2: downpipe and exhaust

  • Downpipes: a 2.75 inch decat downpipe (Milltek) and a 3 inch sports-cat or decat front downpipe (Cobra Sport, fitting the 225 Cup from 2004 to 2009 and the 220, 225 and 230) replace the restrictive standard catalyst with larger pipework from the turbo flange.
  • Turbo-back systems: a 3 inch stainless sports-cat turbo-back is claimed by its maker to add well over 12 bhp and is sold for track or off-road use only. Milltek lists turbo-back and cat-back options for the 225 and the 230 and R26, several of which are stated to require a stage 2 remap.
  • A catalytic converter is needed to pass an emissions inspection in many jurisdictions, so decat parts are not road-legal there.

Step 3: fuel

With larger injectors the guide calls for an uprated drop-in fuel pump of about 255 l/h from a known supplier. That matches the fuelling advice on generic F4Rt tuning pages.

Step 4: turbo

Beyond the standard turbo (reported good for about 320 bhp), the guide describes a hybrid "20T" upgrade using a larger billet compressor wheel, a TD04L turbine wheel and a 360-degree thrust bearing, with pistons and rods advised first. A larger Garrett unit (it names a GTX2867R) is described as the next step for a forged engine. No source for a GT2871 build or for boost and power targets on these builds was found.

Cautions

Each step raises torque on the clutch and cooling system; see the limits page. Gains attributed to parts are vendor claims, and no independent before-and-after dyno data was found.

Sources