Scope: a reported 2014 SEAT Leon 1.4 TSI case
The NefMoto thread “Med17.5.21 1.4tsi reducing requested load/boost” concerns an author's hybrid-turbo 2014 Leon operated at Mexico City altitude. The author reports that specified boost and load taper at higher engine speed, without reported overboost or throttle cuts, and suspects an altitude correction. The thread does not establish a verified limiting map, completed repair or a universally applicable software identity.
A responder suggests investigating compressor pressure-ratio and protection functions, explicitly saying that they have not reviewed the files/log and do not calibrate that particular ECU. The author says a pressure-ratio limiter had already been changed. Other replies challenge the consistency of the edited calibration. Therefore the evidence supports an unresolved diagnostic case, not a proven altitude-limiter fix or permission to increase protection thresholds.
Pressure ratio uses absolute pressure at the compressor
Garrett defines compressor pressure ratio as PR = compressor outlet absolute pressure / compressor inlet absolute pressure. Inlet restriction can put inlet pressure below ambient; charge-system loss means compressor outlet pressure can exceed manifold pressure. A manifold boost gauge and barometric pressure alone may therefore understate the compressor's actual duty. Garrett: choosing a turbocharger.
For illustration only, if compressor outlet pressure is held at 2.20 bar absolute and inlet losses are ignored, PR is 2.20 at 1.00 bar inlet pressure and approximately 2.82 at 0.78 bar inlet pressure. This arithmetic isolates the pressure effect; it does not predict a particular turbo's flow, speed, efficiency or safe operating range. Use absolute pressures in matching units and the fitted compressor's map. Garrett compressor-map guide.
Trace the falling request before tuning the actuator
- Record engine code, ECU hardware/software, turbo and actuator identity, fuel, ambient pressure and temperatures. Preserve a consistent baseline file and its change list.
- Compare the driver torque request, permitted torque, requested load, selected maximum load, pressure setpoint and actual pressure. Determine where the reduction first appears. A falling setpoint with actual pressure following it is a different observation from underboost against an unchanged setpoint.
- Where the logger exposes them, capture the individual limiting contributions and their enable/state signals. Retain modelled compressor-inlet pressure, pressure ratio, charge temperature and turbo-speed/protection estimates with their definition and units.
- Check lambda and fuel-pressure tracking, ignition correction, thermal state and faults during the same interval. The absence of throttle closure does not establish that every torque or component-protection path is inactive.
- Verify the physical compressor operating points and the reason for the selected limit before considering a calibration change. Compare equivalent engine speed, gear and thermal conditions; do not attribute every difference between separate runs to altitude.
This sequence is an inference from the case and compressor fundamentals. It does not identify the limiting function in the author's ECU. A modelled turbo-speed channel is not evidence of a fitted turbo-speed sensor. A replacement turbo labelled “hybrid” does not supply a compressor map or establish the validity of the original protection model.
Keep application and software boundaries
This 1.4 TSI MED17.5.21 case does not establish the pressure limits, actuator maps or fuel system of early 1.8/2.0 EA888 MED17.5, or of MED17.1.1 4.0 TFSI. Follow the request path in the matching software instead of importing a map list from another variant. See MED17.5.21 identification and the MED17 family reference.
Source status
The NefMoto posts are a first-person problem report and proposed explanations, not a verified calibration recipe. Garrett supplies the compressor fundamentals, not a diagnosis of that SEAT. Sources reviewed 16 November 2026; no forum power claim, pressure target or map value is adopted as a tuning recommendation.