Tuning Wiki
Applies to

Check the hardware and software limits stated in this article.

Scope

These diagnostic principles concern VAG ME7.1/ME7.5 examples. Idle functions, logged variables, adaptations and calibration names differ with software and equipment. Identify the ECU and fitted throttle, air meter, injectors, flywheel and other changes first. A stable idle is useful evidence, but it does not by itself prove that injector, air or torque models are correct throughout the operating range.

Why spark can move at idle

Idle speed is regulated as electrical, air-conditioning, steering and transmission loads change. Spark timing is one fast way to alter engine torque; airflow and the associated torque reserve also matter. An oscillating ignition angle can therefore be the controller's response to a disturbance as well as a contributor to a self-sustaining oscillation. It does not alone identify knock or prove that the base timing table is wrong.

In a forum-reported ME7.5 S3 case with substantial engine, throttle and injector changes, speed and ignition oscillated. After several hardware and calibration changes, revising idle control in the LLRRMM function was reported to steady speed and timing, while the custom MAF linearisation remained unresolved. This is a reported multi-change case, not an independently validated recipe or proof that every similar oscillation needs controller tuning.

Log the sequence

  1. Record cold and fully warmed behavior, the requested and actual idle speed, coolant and intake temperatures, battery voltage, fault codes, fuel and adaptation state. Observe whether the oscillation starts with an auxiliary load, a throttle transition or a particular temperature.
  2. Compare actual ignition with requested ignition and, where the matching definition exposes them, idle-control torque correction and idle-control status. In the cited case dmllr_w was traced through the idle torque request; verify its name and scaling on the vehicle being logged.
  3. Log commanded and actual throttle where available, calculated load, air mass, requested and measured lambda, and short- and long-term corrections. Include clutch, gear and air-conditioning state if applicable. Look for which signal changes first, allowing for sampling delays.
  4. Check for intake or exhaust leaks, throttle faults or adaptation issues, unstable fuel pressure, injector mismatch, cylinder misfire and electrical loading before attributing the symptom to an idle controller calibration. Compare one controlled condition at a time.

A separate Porsche example. In a forum-reported ME7.8.4 996 Turbo case, a lean-looking low-speed hesitation followed ignition retard, including examples without the initially suspected cam change. Warm driveability was reported better after several fueling and torque-model changes. The outcome does not isolate a single fix and colder-weather validation was still pending. The Porsche implementation is not proof of identical VAG idle logic; it illustrates why cam state, ignition, load, mixture and the torque model should be examined together.

Clutch take-up is a separate operating state. In a forum-reported modified ME7.5 example, a rolling-speed controller change reportedly resolved take-up oscillation with a light flywheel. A later case in the same thread improved in one condition but oscillated in another after a different change. Compare actual and target speed, vehicle and clutch states, fueling and idle-control flags; see lightweight flywheel and stalling diagnosis. These reports do not prescribe a universal gain.

Torque reserve and practical interpretation

The S4 calibration examples discussed in S4Wiki's idling section include idle torque-reserve maps such as KFMRES and KFMRESK. Their selection and relationships must be established in the exact software; a familiar map name or a value copied from another car does not establish the active path. Reserve, spark and air control interact, so removing reserve or changing controller settings merely to hide an airflow or fueling fault can make load recovery harder to interpret.

Use the injector-change diagnosis, MAF and lambda log review and general idle guide alongside this page. The S4Wiki material is paraphrased from revision 5324 by its contributors under CC BY 4.0; forum outcomes remain the authors' reports.

Continue the conversation

If this topic interests you, consider joining the following forums. They host material referenced in this article.