Tuning Wiki
Applies to

Check the hardware and software limits stated in this article.

Holley Sniper EFI Quadrajet is a carburettor-replacement throttle-body fuel-injection system with integrated electronic control. The handheld is a setup/display device, and the system also requires appropriate fuel delivery, wiring and sensors.

Holley Sniper EFI Quadrajet throttle-body EFI
Holley Holley Sniper EFI Quadrajet family illustration from its installation manual, cover; finish and injector count vary with part number. Manufacturer photograph reproduced with permission.

Applications and versions

Holley’s Quadrajet system is intended to replace a Rochester Quadrajet-pattern four-barrel carburettor. Verify manifold, throttle linkage, fuel supply and air cleaner against the vehicle and the instructions.

Four-injector throttle-body EFI with integrated ECU. Holley's comparison lists up to 500 hp naturally aspirated; 550-867, 550-868 and 550-869 are finish variants. Model numbers: 550-867 / 550-868 / 550-869. See Holley’s Sniper model comparison.

Manufacturer harness connections

The model-specific Holley installation manual, PDF page 9, identifies the seven-way 558-490 main harness and ten-way 558-491 I/O harness below. The ten-way table has eight populated wires; the source does not assign the remaining two cavities. Outputs are relay-control signals: use the source for ratings, ignition configuration and the connector view. The throttle body, 4-pin CAN handheld connection, coolant sensor and oxygen sensor are separate connections.

Seven-way main harness, 558-490

PinWire colourManufacturer function
AVioletCrank signal positive
BDark greenCrank signal negative
CBlueFuel-pump supply from relay
DYellowCoil-negative engine-speed input
ERedBattery positive
FPinkSwitched ignition +12 V
GBlackBattery negative

Ten-way I/O harness, 558-491

PinWire colourManufacturer function
AOrangeInput 1, ground-triggered A/C
BYellowInput 2, programmable ground input
CLight blueOutput 1, fan 1 relay trigger
DLight greenOutput 2, fan 2 relay trigger
EGreyOutput 6, A/C shutdown relay trigger
FWhitePoints output for compatible ignition
GDark brownTachometer output
HTanDigital gauge output

Installation and ignition

The correct fuel pump, filters, sensor placement and ignition setup depend on the kit and vehicle. An RPM input alone does not establish ECU timing control; consult the manual and identify the ignition hardware before wiring.