Tuning Wiki
Applies to

Check the hardware and software limits stated in this article.

Holley Sniper EFI BBD for Jeep CJ is a carburettor-replacement throttle-body fuel-injection system with integrated electronic control. The handheld is a setup/display device, and the system also requires appropriate fuel delivery, wiring and sensors.

Holley Sniper EFI BBD for Jeep CJ throttle-body EFI
Holley Holley Sniper EFI BBD for Jeep CJ family illustration from its installation manual, cover; finish and injector count vary with part number. Manufacturer photograph reproduced with permission.

Applications and versions

Holley identifies this BBD replacement for 1971–1986 Jeep CJ applications using the 258-cubic-inch inline-six and the relevant Carter BBD carburettor arrangement. Check manifold, linkage and fuel system against the exact vehicle and kit.

Two-injector, throttle-body-mounted EFI controller. Holley identifies shiny, black and gold finishes under 550-858, 550-859 and 550-860; K-suffix master packages may include fuel-delivery hardware. Model numbers: 550-858 / 550-859 / 550-860. See Holley’s Sniper model comparison.

Manufacturer harness connections

The model-specific Holley installation manual, PDF page 17, identifies the seven-way 558-490 main harness and ten-way 558-491 I/O harness below. The ten-way table has eight populated wires; the source does not assign the remaining two cavities. Outputs are relay-control signals: use the source for ratings, ignition configuration and the connector view. The throttle body, 4-pin CAN handheld connection, coolant sensor and oxygen sensor are separate connections.

Seven-way main harness, 558-490

PinWire colourManufacturer function
AVioletCrank signal positive
BDark greenCrank signal negative
CBlueFuel-pump supply from relay
DYellowCoil-negative engine-speed input
ERedBattery positive
FPinkSwitched ignition +12 V
GBlackBattery negative

Ten-way I/O harness, 558-491

PinWire colourManufacturer function
AOrangeInput 1, ground-triggered A/C
BYellowInput 2, programmable ground input
CLight blueOutput 1, fan 1 relay trigger
DLight greenOutput 2, fan 2 relay trigger
EGreyOutput 6, A/C shutdown relay trigger
FWhitePoints output for compatible ignition
GDark brownTachometer output
HTanDigital gauge output

Installation and ignition

The correct fuel pump, filters, sensor placement and ignition setup depend on the kit and vehicle. An RPM input alone does not establish ECU timing control; consult the manual and identify the ignition hardware before wiring.