Tuning Wiki
Applies to

Check the hardware and software limits stated in this article.

Holley Sniper EFI 2GC Small Bore is a carburettor-replacement throttle-body fuel-injection system with integrated electronic control. The handheld is a setup/display device, and the system also requires appropriate fuel delivery, wiring and sensors.

Holley Sniper EFI 2GC Small Bore throttle-body EFI
Holley Holley Sniper EFI 2GC Small Bore family illustration from its installation manual, cover; finish and injector count vary with part number. Manufacturer photograph reproduced with permission.

Applications and versions

Holley identifies this small-bore Rochester 2GC carburettor conversion for specified 1955–1969 Chevrolet, Buick, Oldsmobile and Pontiac applications. Confirm flange dimensions, intake and linkage; large-bore 2GC uses a separate kit.

Two-injector self-learning throttle-body system with integrated controller. The three listed part numbers identify shiny, black and gold variants. Model numbers: 550-864 / 550-865 / 550-866. See Holley’s Sniper model comparison.

Manufacturer harness connections

The model-specific Holley installation manual, PDF page 17, identifies the seven-way 558-490 main harness and ten-way 558-491 I/O harness below. The ten-way table has eight populated wires; the source does not assign the remaining two cavities. Outputs are relay-control signals: use the source for ratings, ignition configuration and the connector view. The throttle body, 4-pin CAN handheld connection, coolant sensor and oxygen sensor are separate connections.

Seven-way main harness, 558-490

PinWire colourManufacturer function
AVioletCrank signal positive
BDark greenCrank signal negative
CBlueFuel-pump supply from relay
DYellowCoil-negative engine-speed input
ERedBattery positive
FPinkSwitched ignition +12 V
GBlackBattery negative

Ten-way I/O harness, 558-491

PinWire colourManufacturer function
AOrangeInput 1, ground-triggered A/C
BYellowInput 2, programmable ground input
CLight blueOutput 1, fan 1 relay trigger
DLight greenOutput 2, fan 2 relay trigger
EGreyOutput 6, A/C shutdown relay trigger
FWhitePoints output for compatible ignition
GDark brownTachometer output
HTanDigital gauge output

Installation and ignition

The correct fuel pump, filters, sensor placement and ignition setup depend on the kit and vehicle. An RPM input alone does not establish ECU timing control; consult the manual and identify the ignition hardware before wiring.