FiTech 30020 Go EFI Classic 650HP System is a self-learning carburettor-replacement throttle-body fuel-injection system. FiTech identifies the ECU as a separate, remotely mounted unit; the throttle body has a classic carburettor appearance. The product listing says timing control and forced-induction support are not included.

Identification and fitment
Use the part number to select the correct throttle body, harness, fuel-delivery package and installation instructions. The flange is specified as a four-barrel square bore; some spread-bore manifolds need an adaptor. The product listing identifies the pump as separate from this listed base kit; master kits can differ. FiTech 30020 specifications.
| Item | Manufacturer listing |
|---|---|
| FiTech model | 30020 |
| Manufacturer maximum power | 650 HP |
| Mounting flange | 4-barrel square bore |
| ECU included | Yes |
| Throttle-body finish | Gold |
| Fuel pump included in listed base kit | No |
| Timing control, manufacturer listing | No |
| Power-adder compatible, manufacturer listing | No |
Control and installation
FiTech describes self-learning fuel adjustment after initial setup, using an oxygen-sensor input. A correctly specified high-pressure EFI fuel system, sensors and ignition reference are required; verify the fuel-system and distributor configuration against the model manual. A carburettor-replacement throttle body does not automatically provide every ignition or transmission-control function.
Wiring documentation
Use the FiTech installation documentation for the exact system and revision. A complete numbered ECU connector schedule has not yet been verified for this page; do not substitute the wiring of a visually similar kit.
Harness A: customer connections
FiTech’s 30020 installation manual, page 6, figure 16, identifies these four customer-wired leads by colour. This is the full set in that wire chart, not a numbered ECU cavity pinout; the manufacturer does not assign ECU connector positions in the chart. The system also has separately labelled connectors for its sensors, injector sub-harness and handheld controller.
| Harness lead | Manufacturer-described connection |
|---|---|
| Red | Fuel-pump circuit: the supplied lead provides +12 V to the pump positive terminal; FiTech says no additional relay is required for this harness. |
| Orange | Main power on/off input: switched +12 V present during both key-on and cranking and absent when off. |
| Tan | Tachometer/RPM input. Connect as specified for the selected coil, HEI distributor or CDI tach output in the model’s wiring diagram. |
| Grey | Fan 1 control, to the ground-trigger terminal of the fan relay. |