Tuning Wiki

“Cranks but does not start” means the starter turns the engine but combustion does not establish. It is different from a no-crank complaint. Record whether the failure is hot, cold, intermittent or follows a repair, and whether the engine briefly starts or attempts to fire. Do not assume a failed ECU or change calibration before establishing the cause.

Establish the basics

  1. Identify the vehicle, engine, fuel system and any recent work. Check fuel level and fuel quality, visible damage, disconnected plugs and leaks. A warning lamp or security message may provide useful context.
  2. Check battery condition, cranking speed and the relevant power and earth circuits under load. Scan applicable modules and save fault codes and available snapshots before clearing. Codes direct tests; they do not prove a component is faulty. Vehicle diagnostic workflow.
  3. Check whether the ECU reports a plausible engine-speed signal during cranking. No displayed speed is a useful clue, but the sensor, wiring, supply, trigger wheel and scan data path require investigation. Delphi: crankshaft sensor testing.

Separate fuel, ignition and mechanical causes

Follow the vehicle-specific test sequence for fuel supply, injector control, ignition output and mechanical timing or compression. A pump sound does not prove adequate pressure or flow, and an electrical command does not prove an injector is delivering correctly. Check the prescribed pressure and operating conditions using equipment and procedures suitable for that system. Delphi fuel-system diagnostic tips.

Test ignition with suitable equipment and the manufacturer's procedure; confirm timing and synchronisation where relevant. If fuel and ignition commands appear plausible, consider air intake, compression and valve timing rather than assuming an electronic fault. A flooded engine and a lack of fuel can both prevent starting, so establish which condition exists before changing the tune.

Fuel pressure is hazardous, especially on direct-injection and common-rail systems. Use the specified depressurisation and test procedures; do not loosen high-pressure fittings or improvise electrical bypasses. See common-rail diesel starting diagnosis for that different system.

Use evidence to narrow the fault

Compare cold coolant and intake temperature readings with the actual conditions, and investigate implausible values, wiring or air leaks using the appropriate service information. A valid scan reading does not by itself prove a sensor or its mechanical context is healthy. For intermittent faults, capture the relevant supply, trigger and command signals when the fault occurs; an oscilloscope can show a dropout that a numerical reading misses.

After repairing the established cause, follow any required setup or relearn procedure, confirm reliable starting in the original conditions and recheck faults. Avoid repeated prolonged cranking; follow the vehicle's limits and allow the starter to cool.