Tuning Wiki

Davis Technologies Profiler EFI · Davis Technologies traction control systems

Scope and identification

This table transcribes the P1 20-gauge, 14-position connector in the manufacturer’s Profiler EFI instructions, printed page 19. Refer to the source connector illustration to identify pin numbering and orientation on the actual harness. Confirm controller version, ECU integration and optional features before wiring; do not transfer this table to other controllers solely because their plugs look alike.

P1 assignments

PinWire colourFunctionSource flag
1RedBattery positive / ignition switch
2Yellow with black stripeCAN low* #
3GreenDriveshaft RPM VR sensor input +* #
4WhiteDriveshaft RPM input
5Orange with black stripeTransbrake sync input
6TanArming switch
7Orange with white stripeAnalog input*
8BlackBattery ground
9Yellow with red stripeCAN high* #
10White with black stripeDriveshaft RPM VR sensor input −* #
11OrangeDriveshaft RPM output*
12BlueLaunch sync trigger output, 750 mA, Pos-Neg (manufacturer wording)*
13Light greenCorrection output
14GraySmartDrop output

* = Optional/future-use wire supplied but not installed in the connector, as described in the manual. # = twisted pair. VR means variable reluctance; RPM means revolutions per minute. These markings describe the manual's configuration, not a guarantee that any given used harness is populated as supplied.

Source

Davis Technologies Profiler EFI instructions, printed page 19.