Continental Engineering Services RSX ABS kit, HECU part 3-75000-013, 58-position connector. The table transcribes only positions identified in the ABS-only electrical diagram on page 3 of the manufacturer’s Technical Outline revision 3.0, 2023-02-16. Other positions are not identified here; this is not a generic MK100 pinout.
| Pin | Function |
|---|---|
| 1 | KL30_P battery supply, 40 A fuse |
| 45 | KL30_V battery supply, 40 A fuse |
| 34 | KL15 ignition supply, 5 A fuse |
| 14 | Ground |
| 58 | Ground |
| 39 | FlexRay P, if applicable |
| 24 | FlexRay M, if applicable |
| 31 | Vehicle CAN high |
| 16 | Vehicle CAN low |
| 28 | Baud-rate switch ground |
| 41 | Baud-rate switch signal |
| 27 | Private CAN high to IMU |
| 42 | Private CAN low to IMU |
| 11 | Rear right wheel-speed signal |
| 10 | Rear right wheel-speed ground |
| 9 | Front left wheel-speed signal |
| 8 | Front left wheel-speed ground |
| 7 | Rear left wheel-speed signal |
| 6 | Rear left wheel-speed ground |
| 5 | Front right wheel-speed signal |
| 4 | Front right wheel-speed ground |
| 53 | PS20 pressure sensor SENSEEP |
| 40 | PS20 pressure sensor ground |
| 55 | PS20 pressure sensor signal |
| 47 | ABS warning lamp |
| 56 | Failure-present warning lamp |
| 57 | Tachometer output |
| 43 | Brake-light output |
| 36 | ISO K-line diagnostic |
| 22 | ABS mode switch SENSEEP |
| 29 | ABS mode switch ground |
| 23 | ABS mode switch signal |
| 20 | Not connected in ABS-only diagram |
| 26 | Not connected in ABS-only diagram |
| 21 | Not connected in ABS-only diagram |
| 54 | ABS off switch |
| 50 | Not connected in ABS-only diagram |
Pin 41 open selects 1 Mbit/s; connecting it to pin 28 selects 500 kbit/s, as drawn. Private CAN is separate from vehicle CAN. The configuration and optional interfaces must be matched to the exact system. Source: Continental Engineering Services RSX ABS Kit Technical Outline revision 3.0, pp. 2–3.