Selected ECU positions in the 38-position ABS M5 connector F02U B00 238-01 as drawn in the Bosch M5 Porsche Cup kit manual, figure 13.7 Porsche 991 Cup Gen 1 and figure 13.10 Porsche 991 Cup Gen 2. The listed ECU functions appear in both cited diagrams; unlisted positions are not assigned here. This is not a 997 Cup loom pinout. The sensor/harness branches differ between generations, so use the exact drawing and part numbers for the installation.
| ECU position | Function in the 991 Cup drawings |
|---|---|
| 1 | VBat motor relay; 40 A protection S1 |
| 4 | WS front right, black |
| 5 | V_Stab (+5 V) |
| 7 | Switch 2 |
| 8 | WS front left, black |
| 10 | ABS warning lamp |
| 13 | Motor ground |
| 14 | CAN1 low |
| 16 | WP front right, white |
| 17 | WP rear right, white |
| 18 | WS rear left, black |
| 19 | WP front left, white |
| 20 | CAN2 low |
| 21 | VB switch |
| 22 | Switch 1 |
| 25 | VBat valve relay; 25 A protection S2 |
| 26 | CAN1 high |
| 28 | KL15; 10 A protection S3 |
| 29 | WS rear right, black |
| 31 | WP rear left, white |
| 32 | A_GND |
| 33 | CAN2 high |
| 36 | Front brake pressure |
| 37 | Rear brake pressure |
| 38 | Valve ground |
WS and WP and their wire colours are retained as labelled by Bosch; do not infer sensor polarity from those labels. CAN1 and CAN2 are distinct networks. Bosch warns that connecting an M4 harness to M5 can damage the unit; check connector orientation, loom version, sensors and commissioning requirements in the manufacturer manual.
Source: Bosch Motorsport ABS M5 Kit Porsche Cup manual, pages 50 and 53, wiring diagrams 13.7 and 13.10.