Tuning Wiki
Browse BMW Sunseeker

Sunseeker S20 with BMW M57 power

A 20-foot Sunseeker S20 (also known by the earlier Poole Powerboats name) has been fitted with a BMW M57. The sale listing identifies an E39 530d donor, while the owner's earlier video description identifies an E46 330d; the donor model is therefore uncertain. A steel adaptor plate couples the engine to a Volvo 280 sterndrive. The owner lists a single-mass flywheel and says the drive was rebuilt with the ratios used for a V8. Sources: owner's S20 specification and photo gallery; owner's video on the water.

BMW diesel installed beneath the S20 engine hatch

The M57 in the stern of the S20. Owner's photograph, reproduced with permission.

How the cooling circuits meet

A Yanmar 6BY raw-water pump feeds a stainless-steel heat exchanger. Inside it, heat passes from engine coolant to seawater while the two fluids stay separate. The seawater then discharges into the exhaust. The owner also identifies a water-cooled charge-air cooler. Source: owner's S20 specification and photo gallery.

S20 project engine on a pallet outside the boat

The same project's engine out of the hull. Owner's photograph, reproduced with permission.

For the BMW donor generations, see BMW M57 engine variants.

Larson Cabrio 300 with two M57 engines

A Swedish customer's Larson Cabrio 300 project uses two M57D30 engines with modified original engine controllers, as described by Fekzen. Source: forum project and video.

Larson Cabrio 300 and the two BMW engine controllers

The boat and engine controllers. Image shared by Fekzen on Bimmers.no, reproduced with permission.

Browse all BMW M57 modified builds.

Romkeena's M57-powered boat

A 2022 SNP Production video features a boat with an installed BMW 3.0-litre M57 diesel. Source: boat project video.

SNP Production video cover showing the occupants aboard the M57-powered boat

SNP Production video cover, reproduced with permission.

RixRam's Sea Ray Sundancer 290 project

An M57 from a 2010 BMW X5 xDrive35d was stripped and overhauled in 2023 for a planned installation in a 1993 Sea Ray Sundancer 290. The stated plan was to replace the boat's MerCruiser 454 and couple the diesel to a Bravo III drive. The source shows engine preparation only; completion of the boat conversion is not established. Source: engine overhaul and project introduction video.

RixRam's M57 being prepared outside the boat on the project video cover

RixRam's engine preparation video cover, reproduced with permission.