
Application and identification
AEM's 10-6610 instructions list the following applications; verify engine, market, transmission, ECU connectors and harness revision:
- 1995 Nissan 240SX S14 KA24DE (OBD I).
- 1995–1997 Nissan Sentra and 200SX B14 SR20DE/GA16DE, except 1997 1.6-litre.
- 1995–1996 Nissan Altima U13 KA24DE, except 1996 California models.
- 1994–1996 Infiniti G20 P10 SR20DE.
The manufacturer says the Series 2 30-6610 supersedes 30-1610 and its U variant. This does not mean that the calibration or pin assignments can be transferred without checking. Use AEMTuner; AEM says its older AEMPro software does not support Series 2. AEM's supplied Nissan replacement cam/crank trigger disc is required before engine start; consult its 30-661X trigger-disc supplement and model-specific manual.
Manufacturer connector schedule
The table transcribes all 88 positions listed in the AEM 10-6610 connection chart, pages 10–13: 1–70 and 101–118. Numbers not listed in that chart are not assumed unused. These are wire-view references; consult the source diagram for orientation. “PnP” is configured in the supplied calibration but can be reassigned; “Available” is not allocated by default; “Dedicated” has a fixed function. Factory harness circuits can differ by model year, trim and modifications. Check each actual circuit, output limit and installed jumper.
The manufacturer notes for pins 58 and 64 call them coil outputs but describe switched-ground limits; clarify the drive type with AEM before connecting an ignition circuit.
| Pin | Vehicle harness circuit | AEM EMS function | I/O | Manufacturer notes |
|---|---|---|---|---|
| 1 | Ignition Signal | Coil 1 | Output | PnP for Coil 1, 0-5V falling edge trigger |
| 2 | Ignition Check | EGT 3 | Input | Available, Jumper set for 0-5V input |
| 3 | Tachometer | Tachometer (LS7) | Output | PnP for Tachometer |
| 4 | ECCS Self-Shutoff Relay | Main Relay | Output | Dedicated, EMS activates relay with switched GND |
| 5 | --- | Idle 4 | Output | Available, Ground/+12V, 1.5A max |
| 6 | --- | Idle 3 | Output | Available, Ground/+12V, 1.5A max |
| 7 | M/T 5th position switch (240SX & Altima Only) | ADCR14 | Input | Available, 0-5V Input |
| 8 | Fuel Pump Relay | Low Side 11 | Output | PnP for Fuel Pump |
| 9 | A/C Triple Pressure Switch (Altima & G20)/ A/C Hand Power Switch (240SX) | ADCR11 | Input | Available, 0-5V Input |
| 10 | ECCS Ground | Power Ground | Input | Dedicated |
| 11 | --- | High Side 1 | Output | Available, +12V, 1.5A Max |
| 12 | A/C Triple-Pressure Switch (240SX, Sentra, 200SX Only) | CAN1L | Output | Dedicated, CAN1 low side |
| 13 | Cooling Fan High Relay (240SX & Altima Only) | Low Side 5 | Output | PnP for Cooling Fan |
| 14 | Cooling Fan Low Relay | Low Side 3 | Output | PnP for Cooling Fan |
| 15 | Air Conditioner Relay | Low Side 6 | Output | PnP for A/C Compressor |
| 16 | --- | Idle 2 | Output | Available, Ground/+12V, 1.5A max |
| 17 | --- | Idle 1 | Output | Available, Ground/+12V, 1.5A max |
| 18 | Malfunction Indicator Light | Low Side 10 | Output | Available, Switched ground, 1.5A max |
| 19 | ECCS Ground | Power Ground | Input | Dedicated |
| 20 | Start Signal | Start | Input | Dedicated |
| 21 | Air Conditioner Switch | Switch 6 | Input | PnP for A/C Switch |
| 22 | M/T Neutral Switch | Switch 4 | Input | Available, Switched Input |
| 23 | Throttle Position Sensor | TPS | Input | Dedicated |
| 24 | A/T Signal 1 | ADCR13 | Input | Available, 0-5V Input |
| 25 | Power Steering Oil Pressure Switch | Switch 2 | Input | Available, Switched Input |
| 26 | Vehicle Speed Sensor | Vehicle Speed (T3) | Input | PnP for Vehicle Speed |
| 27 | --- | Switch 5 | Input | Available, Switched Input |
| 28 | --- | --- | --- | Not Used |
| 29 | A/T Signal 2 | Injector 5 | Output | Available, Switched Ground, 1.5A max |
| 30 | A/T Signal 3 | Injector 6 | Output | Available, Switched Ground, 1.5A max |
| 31 | --- | Injector 7 | Output | Available, Switched Ground, 1.5A max |
| 32 | --- | Injector 8 | Output | Available, Switched Ground, 1.5A max |
| 33 | A/T Signal 4 (Throttle Position Signal) | Idle 6 | Output | Available, Switched Ground, 1.5A max |
| 34 | --- | PW 2 | Output | Available, Pulse Width out |
| 35 | Blower Fan Switch (Except 2.0L) | Switch 1 | Input | Available, Switched Input |
| 36 | --- | Coil 4 | Output | Available Coil 4, 0-5V falling edge trigger |
| 37 | --- | Low Side 2 | Output | Available, Switched Ground, 1.5A max (connected to Pin 57) |
| 38 | Ignition Switch | Main Relay | Input | Dedicated, +12V activates Main Relay circuit |
| 39 | ECCS Ground | Power Ground | Input | Dedicated |
| 40 | Camshaft Position Reference Signal | Cam (T2) Signal | Input | Dedicated, Connected to Pin 44 |
| 41 | Camshaft Position Signal | Crank Signal | Input | Dedicated |
| 42 | IACV-AAC Close Valve (Except 2.0L) | --- | --- | Not Used |
| 43 | ECCS Ground | Power Ground | Input | Dedicated |
| 44 | Camshaft Position Reference Signal | Cam (T2) Signal | Input | Dedicated, connected to Pin 40 |
| 45 | Camshaft Position Signal | --- | --- | Not Used |
| 46 | Front Heated Oxygen Sensor | O2 #1 | Input | Dedicated, 0-5V input signal |
| 47 | Mass Air Flow Sensor | MAF | Input | PnP for MAF Sensor |
| 48 | Mass Air Flow Ground | Power Ground | Input | Dedicated |
| 49 | Sensor Power Supply | +5V Sensor | Output | Dedicated |
| 50 | Sensor Ground | Sensor Ground | Output | Dedicated |
| 51 | Engine Coolant Temperature Sensor | Coolant | Input | Dedicated |
| 52 | Rear Heated Oxygen Sensor | O2 #2 | Input | Available, O2 Sensor Input |
| 53 | Crankshaft OBD Sensor | --- | --- | Not Used |
| 54 | Knock Sensor | Knock 1 | Input | PnP for Knock Sensor |
| 55 | Rear Defogger Switch (Except 2.0L) | --- | --- | Not Used |
| 56 | Power Supply for ECM | +12V Switched | Input | Dedicated |
| 57 | Air Conditioner FICD (240SX & Altima only) | Low Side 2 | Output | Available, Switched Ground, 1.5A max (connected to Pin 37) |
| 58 | Data Link Connector for GST | Coil 2 | Output | Available, Switched Ground, 1.5A max |
| 59 | --- | --- | --- | Not Used |
| 60 | Headlamp Switch (except 2.0L) | Switch 3 | Input | Available, Switched Input |
| 61 | Power Supply for ECM | +12V Switched | Input | Dedicated |
| 62 | EGR Temperature Sensor | EGT 1 | Input | Available, Jumper set to 0-5V Input |
| 63 | Intake Air Temperature Sensor | AIT | Input | Dedicated |
| 64 | Data Link Connector for CONSULT | Coil 3 | Output | Available, Switched Ground 1.5A max |
| 65 | Data Link Connector for CONSULT | EGT 2 | Input | Available, Jumper set to 0-5V Input |
| 66 | --- | MAP | Input | Available, Manifold Pressure Sensor |
| 67 | --- | EGT 4 | Input | Available, Jumper set to 0-5V Input |
| 68 | Data Link Connector for CONSULT | Knock 2 | Input | Available, 0-5V Input |
| 69 | --- | CAN1H | Output | Dedicated, CAN1 high side |
| 70 | Back-Up Power Supply | Permanent +12V | Input | Dedicated |
| 101 | IACV-AAC Open Valve | PW1 | Output | PnP for Idle Air Control |
| 102 | Injector 1 | Injector 1 | Output | PnP for Injector 1 |
| 103 | EGRC-Solenoid Valve | Idle 5 | Output | Available, Ground/+12V, 1.5A max |
| 104 | Injector 3 | Injector 3 | Output | PnP for Injector 3 |
| 105 | --- | Low Side 12 | Output | Available, Switched Ground, 1.5A max |
| 106 | ECCS Ground | Power Ground | Input | Dedicated |
| 107 | Injector 2 | Injector 2 | Output | PnP for Injector 2 |
| 108 | Rear O2 Sensor Heater | Low Side 4 | Output | Available, Switched Ground, 1.5A max |
| 109 | Injector 4 | Injector 4 | Output | PnP for Injector 4 |
| 110 | --- | Low Side 9 | Output | Available, Switched Ground, 1.5A max |
| 111 | Rear O2 Sensor Heater Ground | Power Ground | Input | Dedicated |
| 112 | ECCS Ground | Power Ground | Input | Dedicated |
| 113 | Current Return | Permanent +12V | Input | Dedicated |
| 114 | REC Relay (240SX) / Intake VTC Solenoid (1.6L) | Low Side 8 | Output | Available, Switched Ground, 1.5A max |
| 115 | Front O2 Heater (Except Altima and 240SX) | Low Side 1 | Output | Available, Switched Ground, 1.5A max |
| 116 | EVAP Vent | Injector 9 | Output | Available, Switched Ground, 1.5A max |
| 117 | --- | Injector 10 | Output | Available, Switched Ground, 1.5A max |
| 118 | ECCS Ground | Power Ground | Input | Dedicated |
Series 1 migration
AEM identifies these changes from the 30-1610 Series 1 EMS. Following conversion of a V1.19 Series 1 calibration in AEMTuner, the manual says affected functions must be checked and manually reconfigured as directed.
| Pin | Vehicle circuit | Series 1 function | Series 2 function |
|---|---|---|---|
| 12 | A/C triple-pressure switch | --- | CAN1L |
| 69 | --- | Coil 5 | CAN1H |